For Retipping&Regrinding Service of PCD/CBN Tools

For Retipping&Regrinding Service of PCD/CBN Tools

For Tipped PCD inserts and Tipped CBN Inserts, when the cutting edges of them are not sharp, we could regrind the PCD edges and CBN edges again, if the cutting edges are too small or damaged badly, we also could braze them with new PCD edges and CBN edges. Usually the reworking service could save more than 30% cost.

For Solid CBN Inserts, usually we could regrind the used ones into small sizes, such as RNGN120400, when the cutting edges are not sharp or damaged badly, we could regind it into smaller size RNGN090300 or RNGN060300, it could save more than 50% cost.